The most common way to control your pool light is by using a traditional ON/OFF switch. The switch can be flipped up or down to turn it on or off.
Where are pool lights usually located?
The lights should be placed at a uniform depth of 9 to 12 inches below the water line. If the lights need to be placed on a step or bench, there is a chance of an exception. There are lights beneath the waterline.
How do LED pool lights work?
Swimming pools have a lot of Light Emitting Diode (LED) lights in them. The light comes from the semi-conductor which emits light rather than from the burning filaments in the light bulbs. Plug them into the power source and they will work.
Why are pool lights so expensive?
It takes a lot of money to get sales people to go to all the different pool stores. You’re not paying for a better bulb, you’re paying for expensive overhead and multiple mouths to feed when you buy a bulb.
Should pool light have water in it?
It doesn’t mean that the light is leaking, but it does mean that the lamp gasket has failed and water is leaking into the bulb.
Do LED pool lights burn out?
Small light bulbs that fit into an electrical circuit in a lamp are referred to as LEDs. They don’t have a bulb that burns out, which means they run cooler and last longer. Even if only one of the LEDs burns out, the lights will still work.
Do pool lights use a lot of electricity?
An LED pool light costs pennies a day to operate, while an old fashioned bulb costs up to $1 a day. Think of the lights as investments. You’ll pay a bit more up front, but you’ll save a lot of money thanks to the energy savings.
Are LED pool lights worth it?
If you use the same amount of energy as a comparable incandescent light, you’ll save 75% on it. Your cost savings won’t start until you recover the additional money you spent on the LEDs, and that’s because the cost of the lights is more.
Why won’t my pool lights turn on?
It’s a good idea to check the circuit breaker panel on the side of the house. If the breaker that your pool light is on has tripped, you can reset it by turning it off and plugging it back in. It’s possible that you have a bad breaker if that doesn’t work.
How do you reset Pentair pool lights?
The controller needs to be held until the light is reset and the device is switched back on. Try again to see if the lights stay on.